beautypg.com

Normal copying, Copying from the reversing single pass feeder, Sided copies of 1-sided originals – Sharp AR-BC260 User Manual

Page 80: Normal copying -2

background image

5-2

NORMAL COPYING

This section describes the normal copying procedure.

Copying from the reversing single pass feeder

1-sided copies of 1-sided originals

1

Place the originals in the document feeder
tray. (pages 4-6 t
o 4-9)

2

Ensure that the 1-sided to 1-sided copy
mode is selected.

The one-sided to one-
sided mode is selected
when no icon for a two-
sided mode appears in
the dashed area on the
display. If the 1-sided to
1-sided copy mode is
already selected, steps
3 to 5 are not needed.

3

Touch the [2-SIDED COPY] key.

4

Touch the [1-sided to 1-sided copy] key.

It may happen that a
mode other than [1-
sided to 1-sided copy] is
selected, thus [1-sided
to 1-sided copy] should
be selected again.
(Touch the [1-sided to 1-
sided copy] key so that it
is highlighted.)

5

Touch the [OK] key.

6

Ensure that paper of the same size as the
originals is automatically selected. (*Note)

The selected tray will be
highlighted or the
message "LOAD xxxxxx
PAPER." will appear. If
the message appears,
load paper in a paper
tray with paper of the
required size.

Even if the message above is displayed, copying
can be performed onto the currently selected
paper.

(*Note) The following requirements must be satisfied.

Originals of a standard size (11" x 17", 8-1/2" x
14", 8-1/2" x 11", 8-1/2" x 11"R or 5-1/2" x 8-1/2"
(A3, B4, A4, A4R, B5, B5R or A5)) are set and the
auto paper select function is enabled.

If originals of a size other
than the sizes above are
to be copied, manually
select the desired paper
size by touching the
[PAPER SELECT] key
and then touching the
desired paper size
selection key.

The selected key will be highlighted and the paper
selection screen will close. To close the paper
selection screen without making a selection, touch
the [PAPER SELECT] key.

NOTE
Certain restrictions exist depending on the amount of memory installed and the copy settings. (See "Copy mode
output restrictions"
and "Guidelines for the number of scannable originals during sort copying" on page 5-4.)

Original

Copy

11x17

PLAIN

5½x8½

8½x11

8½x11

DUPLEX

8½x11

ORIGINAL

2-SIDED COPY

OUTPUT

0

OK

PAPER SELECT

AUTO 8½x11

100

%

PLAIN

PLAIN

11x17

RECYCLED

8½x14

8½x11

ApollonII_general-copy_SEC.book 2 ページ 2004年9月6日 月曜日 午後4時57分