Sharp AR-BC260 - Manual (Page 37)

2-15
2
REPLACING THE TONER CARTRIDGES
When toner runs low, "[ ] TONER SUPPLY IS LOW" appears in the display. It is recommended that you keep
a set of new toner cartridges so that you can replace them quickly when toner runs out.
Follow these steps to replace the toner cartridge that is out of toner.
1 Open the front cover.
2 Lift the cartridge lock lever toward you.
Example: Replacing the
yellow toner cartridge
3 While holding the lock lever on the toner
cartridge, pull the toner cartridge toward
you.
Hold the toner cartridge
with both hands as
shown in the illustration,
and pull it out of the
machine.
4 Remove a new toner cartridge from the
package and shake it horizontally five or
six times.
READY TO COPY.
([ ]TONER SUPPLY IS LOW.)
CHANGE THE TONER CARTRIDGE.
([ ])
If you continue to use the toner cartridge, the
toner will eventually run out, the machine will
stop and the following message will appear.
This indicates the color of toner that is low.
=
Yellow toner
= Magenta toner
= Cyan toner
= Black toner
Y
M
C
Bk
NOTES
● There may be cases that copy images become light or uneven before the message is displayed, depending on
the way the machine is used. If this occurs, take out the toner cartridge by following the same steps as
replacement, shake it horizontally to even out the toner in the cartridge, and re-insert the toner cartridge.
If copy images do not improve even after following this procedure, replace the toner cartridge with a new
cartridge.
● If one of the toners is out, including black toner, color copying will not be possible. If Y, M, or C runs out but BK
toner remains, black and white copying will still be possible.
Arrangement of color
toner cartridges
Cyan
Magenta
Yellow
Black
NOTE
Shake the toner
cartridge well to ensure
that the toner flows well
and will not stick to the
inside of the cartridge.
ApollonII_general-copy_SEC.book 15 ページ ２００４年９月６日 月曜日 午後４時５７分