Sharp AR-BC260 - Manual (Page 122)

JOB PROGRAM MEMORY
6-26
Recalling a job program
1 Press the [#/P] key.
2 Touch the desired storage register
number key to recall the job from memory.
When a number key is
touched, the selection
screen will be closed
and the stored job
program will be recalled.
A number for which no
job program has been
stored cannot be
selected.
3 Set the number of copies as needed and
press the [COLOR COPY START (
)]
or [BLACK COPY START ( )] key.
Copying will start with
the settings of the
recalled job program.
Deleting a stored job program
1 Press the [#/P] key.
2 Touch the [STORE/DELETE] key to obtain
the storage register screen.
3 Select a storage register number of the
program to be deleted.
If a number key for which
no job program has
been stored is selected,
the screen will change to
the screen of step 4 on
the previous page (for
storing a job program).
4 Touch the [DELETE] key.
When the [DELETE] key
is touched, the screen in
step 3 will return and the
program will be deleted.
If the [CANCEL] key is
touched, the screen in
step 3 will return but the
program will not be
deleted. If no other programs are to be deleted,
touch the [EXIT] key on the screen displayed in
step 3 to exit the job program mode.
JOB PROGRAMS
PRESS PROGRAM NUMBER.
RECALL
NOTE
If any settings related to the contents of a job
program were changed in the key operator programs
after the job program was stored, the changed
settings will not be included when the job program is
recalled.
M NUMBER.
RECALL STORE/DELETE
EXIT
STORE/DELETE
NOTE
If overwriting of programmed copy settings has been
prohibited in the key operator programs, you will not
be able to clear a job program. (See page 16 of the
key operator's guide.)
REC LL STORE/DELETE
A JOB PROGRAM HAS BEEN ALREADY STORED.
STORE ANOTHER PROGRAM?
CANCEL DELETE STORE
ApollonII_general-copy_SEC.book 26 ページ ２００４年９月６日 月曜日 午後４時５７分