Sharp AR-BC260 - Manual (Page 72)

PART NAMES AND FUNCTIONS (The Reversing Single Pass Feeder)
4-4
Touch Panel (main screen of copy mode)
The main screen of copy mode shows messages and keys necessary for copying and settings that can be selected.
Touch a key to make a selection. The main screen of the copy mode will be displayed when the [COPY] key is pressed.*
Message display
Basic status messages are displayed here.
[INTERRUPT] key display area
When interrupt copy is available, the
[INTERRUPT] key will be displayed here. When an
interrupt copy job is being run, a [CANCEL] key will
be displayed here to be used for canceling the
interrupt copy job.
Copy quantity display
Displays the selected number of copies before the
[START] key is pressed or the number of remaining
copies after the [START] key is pressed. A single
copy can be made when "0" displayed.
[2-SIDED COPY] key (page 5-6, 5-9)
Touch to display the duplex copy mode setting
screen.
[OUTPUT] key (page 5-3, 5-8)
Touch to select sort, group, and staple sort.
[SPECIAL MODES] key (page 6-2)
Touch to display the special modes selection
screen.
Original feed display
This lights steadily when an original is placed on
the original table of the reversing single pass
feeder. When "Stream feeding mode" in the key
operator programs is turned on, the display blinks
during the waiting period (about 5 seconds) for
placement of the next original. (See page 12 of the
key operator's guide.)
Paper size display
The display shows the location of the paper trays, the
size of the paper in the trays and the approximate
amount of paper loaded in each tray. The approximate
amount of paper in a tray is indicated by
.
Original size display
Displays the original size only when an original is
placed for copying.
Original display
"AUTO" appears when the automatic original size
detection function is operating, and the original
size appears when the original size has been
entered manually.
[ORIGINAL] key
Use this key to manually enter the original size.
Exposure display
Displays the icon of the selected resolution and the
exposure scale.
[EXPOSURE] key (page 5-10)
Use this key to adjust the copy exposure.
Paper select display
Displays the selected paper size. When the auto
paper select mode has been selected, "AUTO" will
be displayed.
[PAPER SELECT] key (page 5-2, 5-7)
Use this key to select the paper size.
Copy ratio display
Displays the selected copy ratio.
[COPY RATIO] key (page 5-13)
Use this key to select the copy ratio.
SPECIAL MODES
2-SIDED COPY
OUTPUT
READY TO COPY.
11x17
AUTO
ORIGINAL
AUTO
EXPOSURE
AUTO 8½x11
PAPER SELECT
100 %
COPY RATIO
PLAIN
INTERRUPT
5½x8½
0
8½x11
8½x11
DUPLEX
ORIGINAL 8½x11
* Except when the custom
settings screen is displayed.
The screen at left shows the
machine with the duplex
module/2 x 500 sheet paper
drawer and the duplex bypass/
inverter unit installed.
The image will vary depending
on the equipment installed.
ApollonII_general-copy_SEC.book 4 ページ ２００４年９月６日 月曜日 午後４時５７分