Job program memory, Storing a job program, Job program memory -25 – Sharp AR-BC260 User Manual
Page 121: Storing a job program -25, E 6-25)
6-25
6
JOB PROGRAM MEMORY
Frequently used job programs can be stored in each of ten storage registers. This is convenient for quick job recall
without losing time manually reprogramming each aspect of a job. Job programs can be recalled with ease, and the
programs are retained even when the power is turned off. By programming frequently used copy settings, you can
eliminate the bother of selecting the settings each time you use them for a copy job.
●Selection for functions stored as part of a job program, will not be recalled as part of the program if the function has
been disabled or changed by a key operator program.
●To exit the job memory mode, press the [CA] (clear all) key on the operation panel or touch the [EXIT] key on the
touch panel.
Storing a job program
1
Press the [#/P] key.
2
Touch the [STORE/DELETE] key to obtain
the storage register screen.
3
Touch a number key from 1 to 10 on the
storage register screen.
Highlighted storage
register numbers are
registers which already
have programs stored.
4
Make all copier selections to be stored.
The number of copies
cannot be stored.
5
Touch the [OK] key.
The selected settings
will be stored under the
register number
selected in step 3.
If a number key is selected in step 3 that has
already been programmed.
A setting confirmation screen will appear. To
replace the existing program with the new
program, touch the [STORE] key and continue
from step 4. If you do not wish to replace the
existing program, touch the [CANCEL] key to
return to the screen of step 3 and select a different
number key.
M NUMBER.
RECALL
STORE/DELETE
PROGRAMS
ESS PROGRAM NUMBER.
RECALL
STORE/
SPECIAL MODES
2-SIDED COPY
OUTPUT
TO STORE, MAKE SELECTIONS AND PRESS
[OK], TO DELETE, PRESS [CANCEL].
11x17
PLA
5½x
8½x11
8½x11
DUPLEX
NOTE
If overwriting of programmed copy settings has been
prohibited in the key operator programs, you will not
be able to storing a job program. (See page 16 of the
key operator's guide.)
AND PRESS
NCEL].
11x17
AUTO
EXPOSURE
AUTO
ORIGINAL
AUTO 8½x11
PAPER SELECT
100
%
COPY RATIO
PLAIN
CANCEL
OK
5½x8½
8½x11
8½x11
DUPLEX
ApollonII_general-copy_SEC.book 25 ページ 2004年9月6日 月曜日 午後4時57分