beautypg.com

Erase, Erase -5, E 6-5 – Sharp AR-BC260 User Manual

Page 101

background image

SPECIAL MODES

6-5

6

Erase

The erase function is used to erase the shadow lines on copies produced when copying thick originals or books. The
erase modes that can be selected are shown below. The erase width is approximately 1/2" (10 mm) in it's initial
setting.

EDGE ERASE
Eliminates shadow lines around the edges of
copies caused when heavy paper or a book is used
as an original.

CENTER ERASE
Eliminates shadow lines produced by the bindings
of bound documents.

EDGE + CENTER ERASE
Eliminates shadow lines around the edges of
copies and eliminates the shadow at the center of
copies.

1

Touch the [ERASE] key on the SPECIAL
MODES screen.

The erase setting screen
will appear.
The erase icon (

) will

also appear in the upper
left of the screen to
indicate that the function
is turned on.

2

Select the desired erase mode.

Select one of the three
erase modes. The
selected key will be
highlighted.

3

Adjust the amount of erase and touch the
[OK] key.

Use the

and

keys

to adjust the erase width
and then touch the [OK]
key.

4

Touch the [OK] key on the SPECIAL
MODES screen.

Return to the main screen of copy mode.

Original

Copy

ERASE

T

COVERS

EDGE

ERASE

ERASE

CENTER

ERASE

EDGE+CENTER

ERASE

EDGE

CANCEL

OK

1/2

(0 1)

inch

About the steps that follow
If a reversing single pass feeder is being used,
see pages 5-2 through 5-6. If the document
glass is being used, see pages 5-7 through 5-9.

To cancel the erase function, touch the [CANCEL]
key on the erase setting screen.

ApollonII_general-copy_SEC.book 5 ページ 2004年9月6日 月曜日 午後4時57分