SMC Networks EtherNet/IP EX500-GEN1 - Manual (Page 20)

37 36
M12, 5-pin, reverse key, socket
Power supply wiring
When combining EX9-OEP1 ( or EX9-OEP2 ) and EX9-PE1 and using external power
supply, connect the power supply to the power input connector of EX9-PE1.
When selecting power supply, refer to "Handling precautions" ( page 3 ) in this manual.
EX9-PE1 power supply connector No.0
M12, 5-pin, reverse key, plug
EX9-PE1 power input connector No.1
Note : Each signal of connector No.0 is connected to corresponding signal of connector No.1.
The pins whose applications are shown in brackets [ ], are prepared supplementarily
and not used normally.
2
5
3
1
4
1
5
4
2
3
Power supply
connector No.0 Power input
connector No.1
1
Pin No. Power input connector No.1 Power supply connector No.0
Power supply for output devices ( 24VDC ) Power supply for output devices ( 24VDC )
2 Power supply for output devices ( 0V ) [ Power supply for output devices ( 0V ) ]
3
4
5
[ Power supply for sensor ( 24VDC ) ]
[ Power supply for sensor ( 0V ) ]
Ground
[ Power supply for sensor ( 24VDC ) ]
[ Power supply for sensor ( 0V ) ]
[ Ground ]
Keep the waterproof cap mounted on power supply connector No.0 while using
EX9-PE1. This connector is prepared supplementarily and not used normally.
Note
Wiring ( continued )
Pin alignment and connection drawing of the Power Supply Cable
Socket connector pin layout ( Reverse key )
EX9-AC -1
M12
6.4
30 5
50
48.1
Pin No
5
4
3
2
1
Cable color : Signal name
Brown : Power supply for output ( 24VDC )
White : Power supply for output ( 0V )
Blue : [ Power supply to sensor ( 24VDC ) ]
Black : [ Power supply to sensor ( 0V ) ]
Gray : Ground ( PE )