SMC Networks EtherNet/IP EX500-GEN1 - Manual (Page 13)

23 22
Mounting/Wiring
The mounting and removing methods of SI unit are as shown below.
For branch wiring method, refer to subsection "Wiring" ( page 15 ) of section "EX500"
in this manual. As the power to output devices such as solenoid valve is supplied by
branch wiring ( branch cable with M12 connector ), there is no need to supply power
individually. Note 1
For mounting/installation methods of solenoid valve, manifold, etc., refer to the
catalogs, instruction manuals, technical data, etc. of each valve series.
When connecting general purpose output block only, refer to subsection "Mounting"
( page 34 ) of section "EX9 Series General Purpose Output Block" in this manual.
Note 2
SI Unit for SV Series Valves ( EX500-S 01 )
M3 30 : 4 pcs.
( Plus-minus slot
round head screw )
Supply/exhaust block
assembly
SI Unit for VQC Series Valves ( EX500-Q 01 )
Supply/exhaust block
assembly
M3 10 : 2 pcs.
( Hexagon socket head cap
screw ( with spring washer ))
NOTE
Holding with hand so that there will be no gap between SI unit and Air supply/exhaust
block assembly, tighten the bolts. Be sure to tighten each bolt by specified tightening
torque. ( Tightening torque : 0.6N m )
Dimensions ( unit : mm )
54.5
68.5
79.4
28.6
15.5
39
1. SI unit for SV series valves ( EX500-S 01 )
PWR COM
64.4
28
80.3
0
1
10.5
22.2
43.2
60
2. SI unit for VQC series valves
( EX500-Q 01 )
0
1
series
10.5
36
66
80.3
64.4
85.7
22.2
13.2
43.2
60
44
SI UNIT EX500
PWR COM
( EX500-Q 02 )