SMC Networks EtherNet/IP EX500-GEN1 - Manual (Page 10)

16 17
Wiring (continued )
For GW unit – Manifold valve – Input unit manifold configuration
Two communication connectors in SI unit and one communication connector in Input
unit are installed respectively.
To the communication connector ( C2 ) or ( 1 ) of SI unit, connect the branch cable with
M12 connector from GW. To the communication connector ( C1 ) or ( 0 ), connect the
branch cable with M12 connector from Input unit.
To the communication connector of Input unit, connect the branch cable with M12
connector from SI unit.
GW unit
Manifold valve with SI unit
( for SV/VQC series )
Connector ( C1 ) / ( 0 )
Branch cable
with M12 connector
Connector ( C2 ) / ( 1 )
Input unit manifold
Manifold valve with SI unit
( for SV/VQC series )
Terminal plug
NOTE
When no Input unit is connected
to the connector ( C1 ) or ( 0 ) of
SI unit, mount a terminal plug on
the connector.
For GW unit – Input unit manifold configuration
To the communication connector of Input unit, connect the branch cable with M12
connector from GW unit.
Branch cable
with M12 connector
GW unit
Input unit manifold
Type, pin layout and connection diagram of the branch cable with M12 connector ( EX500-AC - )
M12
M12
48
16
52
L
M12
31.3
L
32.3
Straight Connector Type
M12
31.3
28.3
Angle Connector Type
EX500-AC -SSPS
EX500-AC -SAPA
L = 300, 500, 1000, 3000, 5000 ( mm )
14.9
6
6