Sun Microsystems Sun Fire V880 - Manual (Page 90)

Maintenance
90 Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006
14. Insert the first HSI/P card into slot 3 on the I/O board. Make sure that the card is fully
seated. See the following figure.
15. Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps into
place.
16. If installing a second HSI/P card in slot 4, repeat Steps 12 through 15.
17. Remove the ESD wrist strap.
18. Close the left door.
19. Attach the HSI/P quad cables, and connect the switch links to the quad cables by following
the instructions described in Avaya Call Management System Switch Connections,
Administration, and Troubleshooting.
20. Turn on any external SCSI devices, starting with the device that is farthest from the system
and working toward the system.
21. Turn on the system monitor.
22. Turn on the system. Do not put the key switch in the locked position.
As the system powers up, the power LED on the monitor flashes.
23. Press Stop+A simultaneously as soon as the monitor power LED lights steadily and the
Sun logo is displayed on the monitor.
The ok prompt is displayed.