Sun Microsystems Sun Fire V880 - Manual (Page 70)

Maintenance
70 Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006
9. Carefully pull the card from the I/O board. See the following figure.
10. A message similar to the following is displayed in the console window:
11. Place the card on an antistatic mat or in an antistatic bag.
12. Do one of the following:
●
If you are replacing the card, continue with Installing a hot-plug PCI card on page 71.
●
If you are not replacing the card, install a filler panel into the system rear panel, rotate
the purple PCI retaining clip over the back of the filler panel until it snaps into place,
remove the ESD wrist strap, close the side door, and return the key switch to its
original position.
Jun 6 12:55:24 sys_name picld[98]: Device PCI1_CARD removed