Siemens Simatic Industrial PC IPC427C - Manual (Page 144)

Appendix
A.2 Certificates and approvals
SIMATIC IPC427C
144
Operating Instructions, 04/2009, A5E02414743-01
A.2 Certificates and approvals
DIN ISO 9001 certificate
The Siemens quality management system for all production processes (development,
production and sales) meets DIN ISO 9001:2000 requirements.
This has been certified by DQS (the German society for the certification of quality
management systems).
Q-Net certificate no.: DE-001108 QM
Software License Agreement
The device is shipped with preinstalled software. Please observe the respective license
agreements.
Approvals for the USA, Canada and Australia
Product safety
The following approvals are available for the device:
Underwriters Laboratories (UL) according to Standard UL 60950-1, File E115352 and
Canadian National Standard CAN/CSA-C22.2 No. 60950-1 (I.T.E) or according to
UL508, File E85972 and Canadian National Standard CAN/CSA-C22.2 No. 142
(IND.CONT.EQ) or according to Canadian National Standard CAN/CSA-C22.2
No. 14-05
EMC
USA
Federal Communications
Commission
Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Shielded Cables Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
Modifications Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
Conditions of Operations This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.