Siemens Simens Gigaset WLAN dsl/cable SE551 - Manual (Page 46)

46
Configuring the Advanced Settings
Gigaset SE551 WLAN dsl/cable / ENG / A31008-M1029-B101-2x-7619 / configure_router.fm / 03.11.2008
Sc
hablone 200
4_12
_27
You can deactivate this function by entering "0". This means that the connection
will continue to exist even if no data is transmitted. If you have a time-based tariff
this can result in high charges. In this case you should enter a value other than
"0".
This time setting only applies to the Connect on demand option.
– Select Connect manually if you always want to establish and end the connection
to the Internet manually. If you have a time-based tariff this will save you high
connection charges. How to establish a connection manually is described on
page 90.
ì
Click on Test Settings to check the Internet connection. The router will attempt to
connect to the Internet. Any Internet connection already in existence will be closed
first.
You will then be returned to the Internet Connection screen. If necessary, you can
now amend your entries.
ì
If the test was successful, click on OK to apply the settings.
PPPoE pass-through
If you activate the PPPoE pass-through function a PC in the network can connect to the
Internet via its own connection ID. The router puts these connections through.
ì
In the Advanced Settings – Internet menu, select Internet Connection.
ì
Select the option On to activate PPPoE pass-through.
ì
Click on OK to apply the settings.