beautypg.com

Editing a playlist title 10, Adding chapter marker in a playlist, Press set/enter to set the end point of the part – Sharp DV-RW2U User Manual

Page 77: Press \ to select “yes, Press set/enter, Press \ to select “yes” and then press set/enter, Press edit to exit the edit mode, Press edit while the disc is stopped, Press original/play list to select playlist mode

background image

77

EDIT

100

OPEN/
CLOSE

POWER

SKIP

SEARCH

AUDIO

TIMER

ON/OFF

TITLE

MENU

ANGLE

SETUP/

FUNCTION

DNR

RETURN

REV

FWD

SET/

ENTER

VCR PLUS+

TIMER PROG.

REC MODE

PROGRAM

AM/PM

ERASE

STILL/PAUSE

REC

PLAY

STOP

SLOW

F.ADV

DISC

TIMER

CH

DISPLAY

ON

SCREEN

POWER

INPUT

VOL

CH

TV CONTROL

ORIGINAL/
PLAY LIST

SKIP

ZOOM

INPUT

6

Press SET/ENTER to set the end

point of the part.

NOTE

• When erasing a part, select a part that

continues for at least 5 seconds. Parts of less
than 5 seconds duration cannot be erased.

• Parts can be added or erased up to 50

times per title.

• The start point is canceled when

REV

or

SKIP is pressed to go back to

before the start point after the start point
has been set.

• Some playback buttons can be used when

searching for a part (page 74).

• Until you have actually set the range, the

start point and end point can be reset.
After going back to setting the start point
and end point by pressing RETURN,
perform step 5 or step 6 to reselect the
part.

7

Press \ to select “YES”.

RETURN

ENTER

ENTER

EDIT(PL) ADD PART
1 PREVIEW

YES

NO

‰‰:‰‰:5‰

SELECT

8

Press SET/ENTER.

• The part is played back from the start

point to the end point.

RETURN

ENTER

ENTER

EDIT(PL) ADD PART
1 ADD
YES

NO

‰‰:‰‰:5‰
1/‰2 6:1‰AM PL
SELECT

• You can test playback the range from

the added start point to the added
end point.

• It may take up to about 1 minute until

the confirmation screen is displayed.

9

Press \ to select “YES” and then

press SET/ENTER.

• The part is added to the end of

Playlist 1.

• The screen in the step 4 appears.

Editing a Playlist Title

10

Press EDIT to exit the edit mode.

NOTE

• A chapter marker is automatically inserted

at the start point where the part was
added.

• Discs on which parts have been added or

erased more than 51 times for a single title
with another DVD recorder can only be
played back or initialized.

Adding Chapter Marker in
a Playlist

VR MODE

DVD RW

You can put a chapter marker anywhere in a
title.

1

Press EDIT while the disc is

stopped.

• The Original Edit Title List screen

appears.

2

Press ORIGINAL/PLAY LIST to

select Playlist mode.

• The Playlist Edit Title List screen

appears.

3

Perform the steps 2 to 7 of

“Adding Chapter Markers” on

page 66.

• The procedure is the same for

addition of chapter markers of
Original recordings.

NOTE

When adding chapter markers during
editing:
• Allow an interval of at least 5 seconds

between a chapter marker and the chapter
marker you want to add. A chapter marker
cannot be added if this interval is too short.

DV_RW2U#p71-85 .p65

03.1.14, 3:03 PM

77