Sharp DV-RW2U - Manual (Page 23)

23
EZ Set Up
Important! (Caution during EZ Set Up):
• Do not press POWER on the recorder or remote control.
The EZ Set Up function automatically sets the tuner channels and clock when the
antenna cable is connected to the rear of the recorder and the power plug is then
connected to an AC outlet.
Important!
When using a cable box:
• See “CATV or Satellite Receiver Connections” on page 21.
• Leave POWER on the cable box turned on and select a channel that carries EDS signals.
1
Make sure that the antenna cable is connected. For connection configuration, refer to “Basic
Connection” on page 19.
2
Connect the power plug of the recorder to an AC outlet.
3
The tuner channels and clock will automatically be set.
• This recorder can monitor and use time-signals (EDS signals), which are provided by some TV stations, to
automatically adjust the clock. This recorder automatially searches EDS signals, but if you are in a hurry to use timer
recording or know the channel of the EDS signal carrier in you area, follow the procedure in “Auto Clock Setting” or
“Manual Clock Setting”.
NOTE
• If power is supplied to the recorder before the cable is connected, EZ Set Up will not be able to preset the channels into
memory. If this occurs, press RESET in the front of the recorder (See page 101). EZ Set Up function will work again.
• If the power is turned on during EZ Set Up, the Auto Channel setting will be interrupted and the turner channels will not be
able to be preset.
• Auto Clock Setting may take several minutes.
• If the Auto Clock Setting is not completed within 30 minutes, there may be no channels with EDS signals. In this case, set
the clock manually. (See “Manual Clock Setting” on page 26.)
• If the antenna signal is weak, the Auto Clock Setting function may not operate.
• During initial channel setting, the channels are set into the AIR channel setting. To watch CATV channel, select “CATV” on
the CHANNEL PRESET screen. (See “Channel Setting” on page 24.)
During Auto Channel Setting During Auto Clock Setting EZ Set Up complete
POWER OPEN/CLOSE CHANNEL TIMER ON/OFF
REC
DISC TIMER
AV AUTO REC
STANDBY
TIMER DISC IN
POWER
• Channel number is increasing.
• Front Panel Display is turned off
when settiing “CLOCK DISP” in
“OPTION SETUP” to “OFF”.
DV_RW2U#p19-23.p65 03.1.9, 7:32 PM 23