Sharp DV-RW2U - Manual (Page 57)

57
Canceling the Disc Timer
Recording
Follow the procedure shown below when you
want to cancel disc timer recording and use
standard timer recording. (Disc timer
recording is not canceled even after the
recording program has ended.)
■ When a disc containing a disc timer
recording program is set in the recorder
and is ready for recording (the DISC
TIMER indicator and TIMER indicator are
lit)
1
Press TIMER ON/OFF.
The TIMER indicator turns off.
2
Turn on the power.
3
Cancel the disc timer recording.
Refer to page 59 for how to cancel
the disc timer recording.
4
Press and hold DISC TIMER for
at least 2 seconds.
• When you want to use standard timer
recording with a disc containing a
disc timer recording program, cancel
disc timer recording by performing
steps 3 and 4.
• Disc timer recording can also be
canceled by removing the disc
containing the disc timer recording
program.
■ When a disc containing a disc timer
recording program is set in the recorder
and the recorder is in the disc timer
recording mode (only the DISC TIMER
indicator is lit)
Press and hold DISC TIMER for at
least 2 seconds.
Disc Timer Recording
EDIT
100
OPEN/
CLOSE
SKIP
SEARCH
AUDIO
TIMER
ON/OFF
TITLE MENU
ANGLE
SETUP/
FUNCTION DNR
RETURN
REV FWD
SET/
ENTER
VCR PLUS+
TIMER PROG.
REC MODE
PROGRAM AM/PM ERASE
STILL/PAUSE REC
PLAY
STOP
SLOW SKIP
F.ADV
ORIGINAL/
PLAY LIST
DISC
TIMER
CH
DISPLAY
ON
SCREEN
POWER INPUT VOL
CH
TV CONTROL
POWER
ZOOM INPUT
NOTE
• The following causes are possible when the
TIMER indicator is blinking or “ERROR” is
displayed when TIMER ON/OFF has been
pressed.
• A recording has been programmed
having a recording time of 1 minute
• Inadequate available disc space
• The disc is protected
• No disc is loaded in the recorder
• Disc identification is not finished
Repeat the procedure after checking the
recording time and disc.
• Disc timer recording and standard timer
recording cannot be performed
simultaneously.
• Disc timer recording is canceled when the
disc is removed.
Important!
• Recordings cannot be programmed when
the power is turned off or when a VR
mode DVD-RW disc is not set in the
recorder.
DV_RW2U#p54-61.p65 03.1.9, 7:39 PM 57