Sharp DV-RW2U - Manual (Page 73)

73
Adding a Part to the
Playlist
VR MODE
DVD RW
You can select part of an Original title as a
new title to add to the Playlist.
1
Press EDIT while the disc is
stopped.
• The Original Edit Title List screen
appears.
2
Press ORIGINAL/PLAY LIST to
select Playlist mode.
• The Playlist Edit Title List screen
appears.
EDIT(PL) PAGE 1/ 1
NEW
SELECT ENTER RETURN ENTER
• Since a title does not exist at this
point, a title frame that does not
contain a picture is displayed.
• Select a title frame that does not contain
a picture when creating a new Playlist.
3
Press SET/ENTER.
• The Playlist Make screen appears.
EDIT(PL)
MAKE TTL
ORIGINAL
TITLE
PART
SELECT ENTER RETURN ENTER
4
Press ' / " to select “PART” and
then press SET/ENTER.
• The Original title is played back.
RETURN ENTER ENTER
EDIT(PL) MAKE TITLE
1 START POINT
1/1 ‰‰:‰‰:‰5
START POINT
Making a New Playlist (PL)
5
Press SET/ENTER to set the
start point of the part.
• Press |PLAY, FWD , REV,
STILL/PAUSE, SKIP ,
SKIP, SLOW or SKIP SEARCH
to find the start point.
RETURN ENTER ENTER
EDIT(PL) MAKE TITLE
1 END POINT
1/1 ‰‰:‰1:26
END POINT
6
Press SET/ENTER to set the end
point of the part.
RETURN ENTER ENTER
EDIT(PL) MAKE TITLE
1 PREVIEW
YES
NO
‰‰:‰1:26
SELECT
NOTE
• When copying a part, make sure to select a
part that continues for at least 5 seconds.
Parts of less than 5 seconds duration
cannot be copied.
Resetting Start Point and End Point
• Until you have actually set the range, the
start point and end point can be reset.
After going back to setting the start point
and end point by pressing RETURN,
perform step 5 or step 6 to reselect the
part.
7
Press \ to select “YES” to
confirm the part.
EDIT
100
OPEN/
CLOSE POWER
AUDIO
TIMER
ON/OFF
TITLE MENU
ANGLE
SETUP/
FUNCTION DNR
RETURN
REV FWD
SET/
ENTER
VCR PLUS+
TIMER PROG.
REC MODE
PROGRAM AM/PM ERASE
REC
PLAY
STOP
SLOW
F.ADV
DISC
TIMER
CH
DISPLAY
ON
SCREEN
POWER INPUT VOL
CH
TV CONTROL
STILL/PAUSE
SKIP
SKIP
SEARCH
ORIGINAL/
PLAY LIST
ZOOM INPUT
DV_RW2U#p71-85 .p65 03.1.14, 9:38 AM 73