Sharp DV-RW2U - Manual (Page 26)

26
Manual Clock Setting
1
Press SETUP/FUNCTION. The
MENU screen appears. Press ' /
" to select “CLOCK” and then
press SET/ENTER.
M A N U A L
C L O C K
A U T O
2
Press ' / " to select “MANUAL”
and then press SET/ENTER.
3
Press \ / | to select “TIME” and
press ' / " to set time.
Example: 10:28 AM
• Number buttons can be used instead
of ' ' ' ' ' / " " " " " to set time and date. Press
AM/PM to select AM or PM during
time setting.
4
Select and set “DATE”, “YEAR”
and “DST” in turn, in the same
manner as in Step 3.
• See “Automatic Daylight Saving-Time
(D.S.T.) Adjustment”.
Example: Jul. 4, 2003, DST: ON
1 0 : 2 8 A M 7 / 0 4 F R I 0 3 O N
C L O C K
T I M E D A T E Y E A R D S T
S E L E C T : C H A N G E :
E N T E R : R E T U R N : ENTER
5
If the data is correct, press SET/
ENTER to enter.
• The screen returns to normal.
NOTE
• If you entered incorrect data during the
setting procedure, re-enter the correct data
in the following manner:
1 Use \
\ \ \ \ / | | | | | to select the data to be corrected.
2 Set the correct data with ' ' ' ' ' / " " " " ".
3 After correcting the data in Step 2,
press RETURN or SET/ENTER to enter.
• If you press RETURN or SETUP/
FUNCTION to exit the clock setting screen
in Step 4, the data will not be stored.
• If a button is not pressed within 3 minutes
during the setting procedure, the screen
will return to the normal screen.
EDIT
100
OPEN/
CLOSE POWER
SKIP
SEARCH
AUDIO
TIMER
ON/OFF
TITLE MENU
ANGLE
DNR
RETURN
REV FWD
VCR PLUS+
TIMER PROG.
REC MODE
PROGRAM AM/PM ERASE
STILL/PAUSE REC
PLAY
STOP
SLOW SKIP
F.ADV
ORIGINAL/
PLAY LIST
DISC
TIMER
CH
DISPLAY
ON
SCREEN
POWER INPUT VOL
CH
TV CONTROL
SET/
ENTER
SETUP/
FUNCTION ZOOM INPUT
Clock Setting
Automatic Daylight
Saving-Time (D.S.T.)
Adjustment
This recorder is equipped with an internal
Automatic Daylight Saving-Time Adjustment
function. In spring (first Sunday in April) and
autumn (last Sunday in October), the time is
adjusted as shown below. This function has
been preset to ON at the factory. Set the
D.S.T. mode in the clock setting screen.
Spring
Programmed timer recording set within this
time frame (2:00 AM to 3:00 AM) will not be
carried out.
First Sunday in April (D.S.T. is ON)
The clock is automatically
advanced 1 hour.
3:00 AM
1:00 AM 2:00 AM
4:00 AM
Autumn
Because there will be two time frames from
1:00 AM to 2:00 AM, timer programming set
between these times will be influenced by the
time change.
Last Sunday in October (D.S.T. is ON)
The clock is automatically
set back 1 hour.
2:00 AM
2:00 AM 1:00 AM
1:00 AM
NOTE
• If the timer recording program is affected
by the D.S.T. time change, check your TV
listing and find out when it reflects the time
change. Some TV listings will indicate the
time change in the same manner as is
programmed in this recorder, but others do
not show the time change until the next
morning. In that case, when programming
a timer, use the clock setting screen to set
the D.S.T. mode to OFF so the time change
will not be carried out.
DV_RW2U#p24-28.p65 03.1.9, 7:33 PM 26