Sharp DV-RW2U - Manual (Page 36)

36
Audio Setting
VR MODE
DVD RW VIDEO CD AUDIO CD
You can change the audio output channel
between stereo, left channel and right
channel when you play Video CDs and Audio
CDs. You can change the audio output
channel when you play a DVD-RW disc
recorded multiple sounds in VR mode (See
also page 87).
Each time AUDIO is pressed, the
audio channels changes as follows:
VIDEO CD AUDIO CD
L R L+R
VR MODE
DVD RW
It may differs depending on the
recorded sound on the disc. See the
table of SAP on page 87 for details.
NOTE
• When you play a VR mode disc recorded
on a Dual Mono, and if you are listening to
the Dolby Digital sound via the digital
output jack, you cannot select the audio
channel. Set “
Digital OUT” in “PLAY-
BACK SETUP” to “PCM” (See page 81), or
if you want to change the audio channel,
listen via the analog output jacks.
Monitor Output when
Receiving a Stereo or
SAP Broadcast
When receiving a stereo or SAP broadcast,
press AUDIO to change the audio output
mode to select Monitor Output. See the table
of SAP on page 87 for details.
NOTE
• When the signal is weak (it is hard to listen)
in a stereo broadcast, press AUDIO to turn
off “L R” display on the TV screen and
change the audio output mode to MONO.
EDIT
100
OPEN/
CLOSE POWER
SKIP
SEARCH
AUDIO
TIMER
ON/OFF
TITLE MENU
ANGLE
SETUP/
FUNCTION DNR
RETURN
REV FWD
SET/
ENTER
VCR PLUS+
TIMER PROG.
REC MODE
PROGRAM AM/PM ERASE
STILL/PAUSE REC
PLAY
STOP
SLOW SKIP
F.ADV
ORIGINAL/
PLAY LIST
DISC
TIMER
CH
DISPLAY
ON
SCREEN
POWER INPUT VOL
CH
TV CONTROL
ZOOM INPUT
DNR (Digital Noise
Reduction)
DVD VIDEO
VR MODE
DVD RW
VIDEO MODE
DVD RW DVD R VIDEO CD
When the noise contained in recorded
material being played back becomes a
problem, you can reduce the noise to make
the picture clearer. DNR can be set to one of
three levels according to the recorded
material being played back. It is recom-
mended to turn DNR “ON” when playing back
discs that have been recorded in the LP
mode or EP mode, and turn DNR “OFF” when
playing back discs having low noise levels
such as DVD video discs.
1
Press DNR during playback.
• Each time DNR is pressed, the mode
changes between “ON” and “OFF”.
ON
2
When the mode is “ON”, press \ /
| to adjust the level.
• Effects are diminished when \ \ \ \ \ is
pressed.
• Effects are enhanced when | | | | | is
pressed.
NOTE
• About 10 seconds later, the indicator on the
TV will disappear automatically. (Or press
SET/ENTER to turn off the indicator.)
• The DNR function does not work when
setting “PROGRESSIVE” in “PLAYBACK
SETUP” to “ON”.
Changing Image/Audio During Playback
DV_RW2U#p29-36.p65 03.1.14, 11:26 AM 36