SATO CX208/212 - Manual (Page 90)

2. If the product of the values entered for “dd” and “ee” are not equal
to or less than the value of “fff” (i.e.,“ffff” is greater that “dd” x “ee”),
an error will occur and the symbol will not be printed. It is
recommended that these values each be set to “000” and the
printer be allowed to automatically calculate the optimum values.
3. The values for “dd” and “ee” need to be made larger if the security
level is increased.
4. The maximum data length is 2700 characters, but may be less
depending upon:
- the minimum module dimension (“aa”)
- the security level specified by “c”.
- the number of data characters
5. The Reference Point of the PDF417 symbol is the upper-left
corner.
6. The F Sequential Numbering command cannot be used
with this command.
7. The E Line Feed command cannot be used with this
command.
8. The Macro and Truncated PDF417 symbols are not supported.
9. The values 00 H thru 1F H can be specified as print data.
10. This command can be stored in a format.
11. The R Rotate command can be used.
12. The print height of the symbol will vary depending upon the data
specified; numeric only, alpha only or alphanumeric.
Page 86 PN 9001092 Rev. A SATO CX208/212 Printers
CX208/212 Programming Guide