Cutter command – SATO CX208/212 User Manual
Page 37
Cutter Command
Command Structure
aaaa =
Number of labels to print between each cut (0001 to 9999)
Example:
Placement:
Fllowing the
Default:
Cut after each label if cutter installed
Command Function
To control the cutting of labels when using a SATO cutter unit with the
printer. This command allows the cutting of multi-part tags or labels at
a specified interval within a print job.
Input to Printer
Printer Output
This set of commands will print 6 labels, with 2 labels between cuts.
Special Notes
1. You must have the optional printer Cutter installed to use this
function. Contact your SATO representative for more information
2. To use this command, you must have the cutter enabled.
3. If the cut value is set at aaaa = 0000, the cutter is inactive.
4. When using the Cuttter command, the total number of labels
printed is the product of the cut value times the print quantity. For
example, if the cut value is 2 and the print quantity is 20, then 40
(20 sets of 2) labels will be printed.
5. Sending a Cutter command to a printer without a cutter installed
will enable the Backfeed operation.
Page 33
PN 9001092 Rev. A
SATO CX208/212 Printers
CX208/212 Programming Guide