Seiko FB-900 - Manual (Page 52)

1-29 —1. Setting up the printer—
1.
Make sure that the power switch is turned to
off. Connect the signal cable to the printer
and computer.
2.
Specify the following serial interface
parameters on the EXTENDED SETUP
MODE.
● Connecting the printer to the computer
Serial Interface
13
25
1
14
Tighten the screws on both
sides of the connector.
Specify the following serial interface parameters on
the EXTENDED SETUP MODE.
EXTENDED SETUP MODE Default setting Page
#70. INTERFACE Parallel 3-46
#71. SELECT IN ENABLE 0 3-47
#72. PARITY BIT Non 3-47
#73. DATA LENGTH 8 bits 3-48
#74. STOP BIT 1 bit 3-48
#75. PROTOCOL DTR 3-49
#76. BAUD RATE 9600 bps 3-49
#77. SERIAL ERROR Print 3-50
#78. CTS ENABLE No 3-50
#79. CD ENABLE No 3-51
#80. DSR ENABLE No 3-51
#81. BUFFER SIZE 512 KB 3-52