Components and functions – Seiko FB-900 User Manual

Page 19

The names and functions of the printer components are shown below.

Name (See drawing on left.)

Function

1. Paper guide

Adjusts the printing position when feeding paper

manually.

2. Paper stacker

When the optional CSF is used, sheets of paper

are ejected into this paper stacker. Both sides of

the paper stacker should be set up.

3. Liquid crystal display (LCD)

Displays the condition and settings of the printer.

4. Control panel

Displays and sets the printer conditions.

5. Paper rack

If the “OPEN PAPER RACK” message is

desplayed on the LCD when setting the paper

path, open the paper rack.

6. Paper Support Guide

Guide the cut sheet at manuarl feeding.

7. Front Cover Lock release button

To open the front cover, push the two buttons

located on the lower corners of the front cover.

8. Front cover

To mount fanfold paper on tractors or replace the

ribbon cassette, open the front cover.

9. Ribbon cassette

If printed characters vecome pale, replace the

ribbon cassette.

10. Print head

Prints characters on paper.

11. Power switch

Pressing the power switch toggles the power on

and off.

ON: Switch depressed OFF: Switch released

12. Tractor

The tractor pins engage sprocket holes on both

sides of fanfold paper for feeding.

13. Top paper rack

Ejected cut sheets are stacked on the top paper

rack.

14. Top cover

Eject fanfold paper to the top of the printer. If

the “OPEN TOP COVER” is displayed on the

LCD when setting the paepr path, open the top

cover.

15. Rear cover

To eject fanfaold paper to the top of the prieter,

open the rear cover. If the “OPEN REAR

COVER” is displayed on the LCD when setting

the paper path, open the rear cover.

16. AC receptacle

Connect the power to this AC receptacle. The

power is desigated on the rating plate on the back

of the printer.

17. Serial connector

RS-232C interface connector

18. Parallel connector

Parallel interface connector

19. Rear printer cover

When the rear tractor or CSF is used, remove the

rear printer cover.

20. Paper Cutter

Cut the paper after pressing the TEAR OFF key.

●

Components and functions