Seiko FB-900 - Manual (Page 180)

ESC = (27)D(61)D (1B)H (3D)H Specifies MSB 0
ESC > (27)D(62)D (1B)H (3E)H Specifies MSB 1
ESC ? (27)D(63)D (1B)H (3F)H Converts the graphic modes.
n m n m n m (n= "K","L","Y","Z", m = 0
≤
m
≤
40)
Converts the ESC K, ESC L, ESC Y or ESC Z graphic mode
into the ESC * graphic mode.
n : Graphic mode to be converted
m : New graphic mode
The initial setting is as shown below;
ESC K = ESC ✽ 00
ESC L = ESC ✽ 01
ESC Y = ESC ✽ 02
ESC Z = ESC ✽ 03
ESC @ (27)D(64)D (1B)H (40)H Initializes the printer.
Resets the print modes and clears command settings, data in the
print buffer and printing position.
● EPSON Software commands
Decimal Hex
Symbol Function
Code
8-4 — 8. Software commands —
m Graphic mode
Horizontal dot density
dpi (dot/inch)
0 Single-density 60 (8PIN)
1 Double-density 120 (8PIN)
2 Double-speed double-density 120 (8PIN)
3 Quadruple-density 240 (8PIN)
4 CRT I 80 (8PIN)
6 CRT II 90 (8PIN)
32 Single-density 60 (24PIN)
33 Double-density 120 (24PIN)
38 CRT III 90 (24PIN)
39 Triple-density 180 (24PIN)
40 Hex-density 360 (24PIN)
Initialization item Status
• Line feed pitch Specified in setup mode
• Page length Specified in setup mode
• TOF Regarding current line as TOF
• Bottom margin Specified in setup mode
• Vertical tab Setting when power is turned on
• Vertical tab channel Channel 0
• Right & left margins Specified in setup mode
• Horizontal tab Specified in setup mode
• Inter-character pitch 0
• Character pitch Specified in setup mode
• Special effect Canceled
• Down-load character Not cleared
• Character set Specified in setup mode
• Single-direction printing Specified in setup mode
• MSB control Canceled
• According to ESC ?
Graphic mode conversion Canceled
• Justification Canceled
• International character Specified in setup mode
• Character font Specified in setup mode
• Print buffer Cleared
• Communication buffer Not cleared
• Printing position Left margin position