Seiko FB-900 - Manual (Page 195)

●
HP Software commands
ESC & k (27,38,107,#, (1B,26,6B,#, Designates/Cancels automatic scroll mode.
# V 86)D 56)H # =0 (30H) :Designates automatic scroll mode.
# =1 (31H) :Cancels automatic scroll mode.
ESC & k (27,38,107,#, (1B,26,6B,#, Controls print direction. (Available in PCL3+ or PCL3+D)
# W 87)D 57)H Print direction is set as follows.
# = 0 (30H) :Unidirectional Print(left to right)
# = 1 (31H) :Bidirectional Print
# = 2 (32H) :Pre-directional Print
ESC & l (27,38,108,#, (1B,26,6C,#, Designates paper size.
# A 65)D 41)H Paper size is set as follows.
# = 0 (30H) :(Setting in the setup mode)
# = 2 (32H) :Letter
# = 3 (33H) :Legal
# = 26 (32H,36H) :A4
# = 81 (38H,31H) :ENVELOP Commercial-10
ESC & l (27,38,108,#, (1B,26,6C,#, Sets VMI (Vertical motion index).
# C 67)D 43)H VMI is set by 1/48 inch.
VMI is defined as the distance where the print position moves
when the LF code is input. If # is 8, the print position moves
in 6 LPI vertically.
ESC & l (27,38,108,#, (1B,26,6C,#, Sets the line spacing. VMI (Vertical motion index)
# D 68)D 44)H # = The number of LPI (lines per inch).
# = 8 (38H) :8 LPI
ESC & l (27,38,108,#, (1B,26,6C,#, Sets top margin by VMI. (where # = “1,2, ...)
# E 69)D 45)H When the top margin is set, the text length is set to the default.
In case of skip perforation ON
Text length = page length- top margin-1/2"
(Bottom margin is set to 1/2")
In case of skip perforation OFF
Text length = page length- top margin
(Bottom margin is set to 0")
ESC & l (27,38,108,#, (1B,26,6C,#, Sets text length.
# F 70)D 46)H Text length is set by line (VMI).
ESC & l (27,38,108,#, (1B,26,6C,#, Sets paper path.
# H 72)D 48)H The mode set as follows.
# = 0 (30H) :Ejects Paper.
# = 1 (31H) :Feeds paper with the CSF.
# = 2 (32H) :Feeds manually loaded paper.
# = -1 (2DH,31H) :Feeds paper with the front tractor.
# = -2 (2DH,32H) : Feeds paper with the rear tractor.
# = -10 (2DH,31H,30H) :Ejects paper to the front.
# = -11 (2DH,31H,31H) :Ejects paper to the top
# = -11 (2DH,31H,32H) :Ejects paper to the rear.
When the "NOT INSTALL" is selected in the" SETUP #60
OPTION," the CSF command is the same as #=0.
Decimal Hex
Symbol Function
Code
8-19 — 8. Software commands —