Sharp AR-407 - Manual (Page 6)

1-2
CHAPTER
1
INSTALLATION REQUIREMENTS
To ensure safety and proper machine performance, please note the following
before initial installation and whenever the machine is to be relocated.
1. The copier should be installed near an accessible power outlet for easy
connection.
2. Be sure to connect the power cord only to a power outlet that meets the
specified voltage and current requirements.
Also make certain the outlet is properly grounded.
● For this copier’s power supply requirements, see the name plate
located on the left hand side at the rear corner of the copier.
3. Do not install the machine where it is:
● damp or humid,
● exposed to direct sunlight,
● extremely dusty,
● poorly ventilated,
● subject to extreme temperature or humidity changes (e.g., near an air
conditioner or heater).
4. Since a hard disk drive is built into this copier, place the copier on a firm,
level surface. Choose an area which is not subject to any vibration.
5. Be sure to allow the required space around the machine for servicing and
proper ventilation.
GETTING STARTED
Installation requirements
30 cm
(11-13/16")
60 cm
(23-5/8")
60 cm
(23-5/8")
30 cm
(11-13/16")