Sharp AR-407 - Manual (Page 172)

8-22
CHAPTER
8
KEY OPERATOR PROGRAMS
Preheat Mode Setting
Preheat mode functions to control the power consumption by lowering
the temperature of the fusing unit to a programmed level once a
programmed length of time has elapsed without any copier operation
after the last copy of a run is made or power is turned on. This function
lowers user’s electricity bill, reduces waste of natural resources, and
cuts down on environmental pollution. The programmed time is set to
15 minutes for this function on completion of shipment from the factory.
The default time can be changed optionally within the prescribed range
of time. We suggest you set the most appropriate time according to
your usage pattern.
This program is used to set the time that elapses before the copier
enters the preheat mode after copying is completed. The interval can
be set between 1 and 240 minutes in 1 minute increments.
When the “PREHEAT MODE SETTING.” key is pressed, the following
display will appear.
1. Set the desired time interval using the and keys.
2. Press the “OK” key.
Noise Level Reduce Mode
When the copier is programmed to enter the noise level reduce mode,
the noise level will be reduced in the standby mode, however, the first
copy time will be several seconds longer when the copier is in this
mode. This program is used to set the time that elapses before the
copier enters the noise level reduce mode after copying is completed.
When the “NOISE LEVEL REDUCE MODE.” key is pressed, the
following display will appear.
1. Set the time using the and keys.
● To enable the time setting, press the check box of the
“CANCEL TIMER” to clear the check mark in the check box.
2. Press the “OK” key.
KEY OPERATOR PROGRAMS
PREHEAT MODE SETTING.
SET THE TIME FOR PREHEAT MODE.
15
(1~240)
min.
OK
TIME:
KEY OPERATOR’S GUIDE
Key operator programs
KEY OPERATOR PROGRAMS
NOISE LEVEL REDUCE MODE
SET THE TIME FOR NOISE LEVEL REDUCE MODE.
(10~240)
sec.
CANCEL TIMER
OK
TIME