Sharp AR-407 - Manual (Page 41)

3-7
CHAPTER
3
4 Select the desired erase mode.
● Select “EDGE ERASE”, “CENTRE ERASE” or “EDGE+CENTRE
ERASE” on the touch panel. The selected erase mode will be
highlighted.
5 Adjust the amount of edge erase and/or centre erase if
needed.
● The amount can be adjusted between 0 mm and 20 mm in 1 mm
increments (0" and 1" in 1/8" increments).
6 Press the upper “OK” key on the touch panel.
7 Make all other desired copier selections and press the
START (
) key.
● If the document feeder is used, scanning of originals and copying
will start.
● If the document glass is used in the SORT mode, proceed to the
next step.
8 Replace the finished original with the next original after
the START (
) key indicator lights up, and then press
the START ( ) key. Repeat this step until all originals
have been scanned. Then, press the “READ-END” key
on the touch panel.
● Copying will start at this time.
● Up to 120 sheets of A4 (8-1/2" x 11") originals or up to 60 sheets
of originals larger than A4 (8-1/2" x 11") can be scanned.
● To cancel the ERASE function, select the ERASE function again
and press the “CANCEL” key.
SPECIAL FUNCTIONS
Erase
READY TO COPY.
ERASE
EDGE ERASE
CENTRE ERASE
EDGE+CENTRE
ERASE
CANCEL
1
OK
OK
(0~1)
inch
ERASE
EDGE ERASE
CENTRE ERASE
EDGE+CENTRE
ERASE
CANCEL
10
OK
OK
(0~20)
mm
CANCEL
1
OK
OK
(0~1)
inch
C
CLEAR
INTERRUPT
CA
CLEAR ALL
START
ERASE
READ-END
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
AUTO A4