Sharp AR-407 - Manual (Page 171)

8-21
CHAPTER
8
KEY OPERATOR PROGRAMS
TIMER SETTINGS
The programs of this category are used to set the timers for some
functions. These programs can be selected by pressing the “TIMER
SETTINGS” key and then selecting the desired program key.
Auto Power Shut-off Timer
The auto power shut-off mode is a function to turn off the power
automatically once a programmed length of time has elapsed without
any copier operation after the last copy of a run is made or power is
turned on.
This function lowers the user’s electricity bill, reduces waste of natural
resources, and cuts down on environmental pollution.
The programmed time is set to 60 minutes for this function on
completion of shipment from the factory. The default time can be
changed optionally within the prescribed range of time. We suggest
you set the most appropriate time according to your usage pattern.
Use this program to set the time interval. The time until auto power
shut-off occurs can be set in 1 minute increments up to a 4 hour
maximum.
When the “AUTO POWER SHUT-OFF TIMER.” key is pressed, the
following display will appear.
1. Enter the time interval using the and keys.
2. Press the “OK” key.
Auto Clear Setting
Use this program to set the time interval to return the copier to the initial
settings after the last copy of a run has been completed. The time can
be set from 10 to 240 seconds in 10 second increments.
When the “AUTO CLEAR SETTING.” key is pressed, the following
display will appear.
1. Set the desired time interval using the and keys.
● To disable the auto clear, press the check box of “CANCEL
TIMER” to display a check mark in the check box.
2. Press the “OK” key.
KEY OPERATOR PROGRAMS
AUTO POWER SHUT-OFF
TIMER.
SET THE TIME INTERVAL FROM LAST COPY
UNTIL POWER OFF IN 1 MIN. INCREMENTS.
60
(1~240)
min.
OK
TIME:
KEY OPERATOR PROGRAMS
AUTO CLEAR SETTING.
SET THE TIME FOR AUTO CLEAR.
CANCEL TIMER
60
(10~240)
sec.
OK
TIME:
KEY OPERATOR’S GUIDE
Key operator programs