Sharp AR-407 - Manual (Page 178)

8-28
CHAPTER
8
Disabling of Bypass-Tray When Offset Tray Selected
This program is used to disable the use of the bypass tray when the
offset tray is selected for an optional finisher (AR-FN2 only).
To disable use of the bypass tray when the offset tray is
selected, press the “DISABLING OF BYPASS-TRAY WHEN
OFFSET TRAY SELECTED.” box to display a check mark.
To restore use of the bypass tray, press the checked box
again to clear the check mark.
OTHER PROGRAMS
The following two programs are not included in the four categories. The
programs can be selected by pressing the relevant key on the touch
panel after the key operator program mode is selected.
Total Count
This program is used to display the total counts, including counts of the copier,
document feeder, duplex module, and stapler.
An A3 (11" x 17") copy is counted as two copies.
Covers and transparency inserts are counted as one copy even if they are
blank.
The lists printed with the key operator programs are included in “OTHERS”.
When the “TOTAL COUNT.” key is pressed, the following display will appear.
The total counts for all units in use will be displayed.
To print these counts, press the “PRINT” key.
Press the “OK” key to exit the program.
Program List Printout
This program is used to print out the list of available key operator
programs.
Press the “PROGRAM LIST PRINTOUT.” key.
● The copier will start printing. To stop printing after starting, press
the “CANCEL” key.
KEY OPERATOR’S GUIDE Key operator assistance call
KEY OPERATOR PROGRAMS
TOTAL COUNT.
COPIES : 022,500
STAPLER : 003,000
OTHERS : 000,500
DOCUMENT : 012,000
FEEDER
DUPLEX
: 007,500
PRINT
OK
KEY OPERATOR PROGRAMS