Sharp AR-407 - Manual (Page 152)

8-2
CHAPTER
8
KEY OPERATOR CODE NUMBER
Registering the key operator code number
1 Press the CUSTOM SETTINGS ( ) key.
2 Press the “KEY OPERATOR PROGRAMS” key on the
touch panel.
● The following display will appear.
3 Enter your key operator code number using the 10-key
pad.
● When registering the key operator code number for the first time,
enter the number that was set at the factory. (See page 8-31.)
● As the code number is entered, the dashes in the display will
change to asterisks.
4 Press the “COPIER” key on the touch panel.
5 Press the “OTHER FUNCTION SETTINGS” key.
CUSTOM SETTINGS
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
AUTO A4
EXIT
DISPLAY
CONTRAST KEY OPERATOR
PROGRAMS
KEY OPERATOR PROGRAMS EXIT
COPIER
TOTAL COUNT.
PROGRAM LIST
PRINTOUT.
COPIER PDA/ZR
KEY OPERATOR PROGRAMS
COPIER MODE
OTHER FUNCTION
SETTINGS
ENABLE/DISABLE
SETTINGS
TIMER SETTINGS
ACCOUNT CONTROL
OK
KEY OPERATOR PROGRAMS
ENTER KEY OPERATOR CODE.
EXIT
KEY OPERATOR CODE
- - - - -
A key operator code number must be registered before a key operator
program can be used. The key operator must remember this number. Only
this registered number will allow access to the key operator programs.
KEY OPERATOR’S GUIDE
Key operator code number
1 2 3
4 5 6
0
C
7 8 9
P
CLEAR
PROGRAM AUDIT CLEAR
INTERRUPT