Siemens Gigaset E450 - Manual (Page 9)

8
First Steps
Gigaset E450 / USA EN / A31008-M1702-R301-2-6019 / starting.fm / 13.4.07
Please remember:
u Always repeat the charging and dis-
charging procedure if you remove the
battery pack from the handset and
insert it again.
u The battery pack may feel warm as it is
charging. This is normal.
¤
Set the date and the time, for example
to ensure the correct time of incoming
calls is recorded.
Setting the date and time
¤
To set the date and time, press the dis-
play key §Time§ to open the input menu.
To change the time, open the input field
via:
v
¢
Ð
¢
Date/Time
¤
Change multiple line input:
Date:
Enter month, day and year in 6-digit
format.
Time:
Enter hours and minutes with 4 digits,
for example Q M 1 5
for 7:15 am.
If you have selected the 12-hour time for-
mat, use the display key §am/pm§ to switch
between am and pm.
Time mode:
Choose between 12 and 24-hour time
format.
§Save§ Press the display key.
Area codes
In order to call back a caller using the
incoming caller ID list (page 16), your
phone's area code ("local area code")
must be stored. If your phone is in a "mul-
tiple area code" area, the extra codes for
this area must also be stored.
Local Area Code
v
¢
Ð
¢
Base
Local Area Code
Select and press §OK§ .
~ Enter local area code.
§Save§ Press the display key.
a Press and hold (idle status).
Extra Codes
v
¢
Ð
¢
Base
Extra Codes Select and press §OK§ .
~ Enter extra code.
§Save§ Press the display key.
a Press and hold (idle status).
Repeat the above steps until all extra
codes for your area have been entered. A
maximum of 5 extra codes can be stored.
Display in idle status
Once the phone is registered and the time
set, the idle display looks as shown here
(example).
Your phone is now ready for use.
Ð V
INT 1
12.23.06 07:15
INT Menu