Setting up the handset for use, Fitting the battery pack – Siemens Gigaset E450 User Manual

Page 7

First Steps

Gigaset E450 / USA EN / A31008-M1702-R301-2-6019 / starting.fm / 13.4.07

Please note:

The power adapter must be always

connected, as the phone will not oper-

ate without an electrical connection.

Setting up the handset for use

Fitting the battery pack

Insert the plug into the socket as shown

in the enlarged view.

Insert the battery pack.

Place the cords in the cord routing.

Closing the battery cover

Hold the battery cover at a slight angle

and install the two lower clips into the

casing first. Then close the cover, press

on the top so that it clicks into place.

Locking the battery cover

Insert the catches on the lock ring or belt

clip into the notches in the casing and

make sure that the arrow markings on the

casing are facing those on the bottom of

the ring. Turn the lock ring or belt clip

clockwise to the end stop. When both

holes are horizontally aligned with the

upper edge of the handset the lock ring is

closed.

Caution:

Use only the rechargeable battery pack recom-

mended by Siemens (page 31). Never use a

conventional (non-rechargeable) battery pack,

as this may cause significant damage to health

and property. For example, the outer casing of

the battery pack could be destroyed or the bat-

tery pack could explode. The phone could also

malfunction or be damaged as a result of using

batteries that are not of the recommended

type. Use of battery packs not authorized by

Siemens may void the warranty on this prod-

uct.