Specifications, Recommended battery pack, Handset operating times/charging times – Siemens Gigaset E450 User Manual
Page 32: Base station power consumption, General specifications
31
Appendix
Gigaset E450 / USA EN / A31008-M1702-R301-2-6019 / appendix.fm / 13.4.07
Specifications
Recommended battery pack
(Valid at the time of going to press)
Nickel-metal-hydride (NiMH):
V30145-K1310-X382
The handset is supplied with the recom-
mended battery pack.
Handset operating times/charging
times
The operating and charging times apply
only when using the recommended bat-
tery pack.
Base station power consumption
In standby mode: approx. 2 watts
During a call: approx. 3 watts.
General specifications
¥
Correct phone jack assignment
l
The other party cannot hear you.
You have pressed the
u
(INT) key. The hand-
set is "muted".
¥
Switch on the microphone again (page 10).
The incoming call number is not displayed
although CIP is set.
Caller ID is not enabled.
¥
Caller should ask network provider to acti-
vate Caller ID (CI).
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the operating
instructions if necessary.
You cannot listen to messages on the net-
work mailbox.
Your phone system is set for pulse dialing.
¥
Set your phone system to tone dialing.
Capacity 620
mAh
Standby time
Approx. 160 hours (6 days)
Calling time
Approx. 12 hours
Charging time
approx. 6 hours
3
2
1
4
5
6
1 unused
2 unused
3 a
4 b
5 unused
6 unused
Note:
When the display lighting is switched on, the
standby time of the handset is reduced to
approx. 30 hours.
DECT standard
is supported
GAP standard
is supported
No. of channels
60 duplex channels
Radio frequency
range
1920 – 1930 MHz
Duplex method
Time multiplex,
10 ms frame length
Channel grid
1728 kHz
Bit rate
1152 kbit/s
Modulation
GFSK
Language code
32 kbit/s
Transmission
power
10 mW, average power per
channel
Range
up to 328 yards outdoors,
up to 55 yards indoors
Base station
power supply
110 V ~/60 Hz
Environmental
conditions for
operation
+41°F to +113°F;
20 % to 75 % relative
humidity
Dialing mode
DTMF (tone dialing)/
DP (dial pulsing)
Base station
dimensions
4.8 x 4.29 x 2.87 inches
(L x W x H)
Handset
dimensions
5.63 x 2 x 0.98 inches
(L × W × H)
Base station
weight
4.3 ounces
Weight of handset
with battery pack 4.7 ounces