Changing the name of a handset, Changing internal number of a handset, Using a handset as a room monitor – Siemens Gigaset E450 User Manual

Page 22

Using several handsets

Gigaset E450 / USA EN / A31008-M1702-R301-2-6019 / registr_sett.fm / 13.4.07

Changing the name of a handset

The names "INT 1", "INT 2" etc. are

assigned automatically at registration.

You can change these names. The name

must be no more than 10 characters. The

changed name is displayed in every hand-

set's list.
u

Open list of handsets. Your

own handset is indicated by

Select handset.

§Edit§

Press the display key.

Enter name.

§Save§

Press the display key.

Changing internal number of
a handset

A handset is automatically assigned the

lowest unassigned number when it is reg-

istered. If all the numbers have been

assigned, number 6 is overwritten, assum-

ing the handset is in idle status. You can

change the internal number of all regis-

tered handsets (1–6).
u

Open list of handsets. Your

own handset is indicated by

§Options§

Open menu.

Edit H/Set No.

Select and press

§OK§

. The list of

handsets is displayed.

The current number flashes.

Select a handset.

Enter the new internal number

(1–6). The handset's old

number is overwritten.

§Save§

Press the display key to save

the input.

Press and hold (idle status).

You will hear the error tone (descending

tone sequence) if you assign an internal

number twice.

Repeat the process with an unused

number.

Using a handset as a
room monitor

If the room monitor is activated, a previ-

ously stored destination number is called

as soon as a set noise level is reached. You

can store an internal or external number

in your handset as the destination

number.
The room monitor call to an external

number stops after approx. 90 seconds.

The room monitor call to an internal

number (handset) stops after approx. 3

minutes (depending on the base station).

While the room monitor is activated, all

keys are locked except the end call key.

The handset's speaker is muted.
When the room monitor is activated,

incoming calls to the handset are indi-

cated without a ringtone and are only

shown on the screen. The display and key-

pad are not illuminated and advisory

tones are also turned off.
If you accept an incoming call, the room

monitor mode is suspended for the dura-

tion of the call, but the function remains

activated.
If you switch off the handset, the room

monitor mode is deactivated. You will

need to reactivate the function after

switching on the handset again.

Caution:

– You should always check the operation

of the room monitor before use. For

example, test its sensitivity. Check the

connection if you are diverting the room

monitor to an outside number.

– When the function is switched on the hand-

set's operating time is severely reduced.

If necessary, place the handset in the

charging cradle. This ensures that the

battery pack will not run down.

– Ideally the handset should be positioned

1 to 2 meters away from the sound being

monitored. The microphone must be

directed towards the monitored sound.

– The connection to which the room monitor

is diverted must not be blocked by an acti-

vated answering machine.