beautypg.com

Setting – Sanyo PLC WM5500L User Manual

Page 53

background image

5

Setting

Capture

Capture

This function enables you to capture an image being projected to
use it for a starting-up display or interval of presentations.

Select Capture and press the SELECT button.
A confirmation box appears and select yes to capture the projected
image.

After capturing the projected image, go to the Logo select function
and set it to User. Then the captured image will be displayed the
next time you turn on the projector.

To cancel the capture function, select yes in the "Quit?" confirmation
box.

Note:

• Before capturing an image, select Standard in the Image Select

Menu to capture a proper image (pp.40, 46).

• A signal from a computer can be captured up to WXGA (1280 x

800). A signal from video equipment can be captured except for
720p, 1035i, 1080i and 1080p.

• When capturing the image that has been adjusted by the

Keystone function, the adjusted data is automatically reset and
the projector captures an image without keystone correction.

• When Logo PIN code lock is set to On, Capture cannot be

selected.

• When starting to capture a new image, the previously stored

image is cleared even if you cancel the capturing.

• When there is no captured image or it is interrupted while

capturing an image, User can not be selected, you can only
switch between Default and Off.

• Capture function is not available when the Picture in Picture

function is set to User1-5.

Logo PIN code lock

This function prevents an unauthorized person from changing the
screen logo.

Off ............. The screen logo can be changed freely from the

Logo Menu (p.52).

On ............. The screen logo cannot be changed without a Logo

PIN code.

If you want to change the Logo PIN code lock setting, press the
SELECT button and the Logo PIN code dialog box appears. Enter
a Logo PIN code by following the steps below. The initial Logo PIN
code
is set to "4321" at the factory.

Logo PIN code lock