Sanyo PLC WM5500L - Manual (Page 26)

6
Basic Operation
For detailed functions of each menu, see “Menu Tree” on pages 76-78.








Main Menu Sub-Menu


 Image select
For computer source, used to select an image level among Dynamic, Standard, Real, and Image 1-10 (p.40).
For Video source, used to select an image level among Dynamic, Standard, Natural, Cinema, and Image 1-10 (p.46).
 Image adjust
For computer source, used to adjust the computer image. [Contrast/Brightness/Color temp ./White balance (R/G/B)/
Offset(R/G/B)/Sharpness/Gamma/Reset/Store] (pp.41-42).
For video or HDMI source, used to adjust the video image. [Contrast/Brightness/Color/Tint/Color temp ./White
balance (R/G/B)/Offset (R/G/B)/Sharpness/Gamma/Noise Reduction/Progressive/Reset/Store] (pp.47-48).
 PC adjust
Used to adjust the parameters to match with the input signal format (pp.37-39).
 Screen
For computer source, used to adjust the size of the image. [Normal/Full/Wide(16:9)/Zoom/True/Custom/Custom adj ./
Digital zoom +/-/Keystone/Ceiling/Rear/Screen aspect/Reset] (pp.42-44).
For video or HDMI source, used to adjust the size of the image. [Normal/Full/Wide(16:9)/Zoom/Natural Wide/Custom/
Custom adj ./Keystone/Ceiling/Rear/Screen aspect/Reset] (pp. 49-50).
 Input
Used to select an input source (Input 1, Input , Input or Network) (p.33).
Note: Network will be not displayed when optional PJ-Net Organizer is not attached.
 Sound
Used to adjust the volume or mute the sound (p.28).
 Information
Display the input source information: Input, H-sync freq ., V-sync freq ., Screen, Language, Lamp status, Lamp counter,
Filter counter, Power management, Key lock, PIN code lock, Shutter management, Simple mode, Remote control,
and SERIAL NO . (p.29).
 Guide
The key operation is displayed.
 Setting
Used to set the projector’s operating configurations (pp.51-65).
 Network
See the owner’s manual of “Network Set-up and Operation”.
Menu Bar