Woodstock W1812 User Manual
Page 25
-22-
N(/()Fne\ijDXelXcD]^%j`eZ\*&'0
FG
<
I
8
K@FEJ
—If a certain moulding knife profile does not allow
you to adjust the outfeed roller down far enough
for proper roller traction, the eccentric stop must
be repositioned to the lower hole. To do this,
remove the jam nut (Figure 28), reposition the
eccentric stop (Figure 29) in the lower hole, and
finger tighten the jam nut. Next rotate the eccen-
tric stop to lower or raise the roller and retighten
the jam nut.
=`^li\28.Feed roller stop adjustment.
Jam Nut
Lower
Hole
=`^li\29.Eccentric stop.
Eccentric Stop
=`^li\30.Feed roller tension adjustment.
3. Loosen and back off the four spring tensioner jam
nuts (
=`^li\30) completely, and unthread the ten-
sioner assemblies until you are sure that they are not
touching the springs.
+. Thread the tensioners back into the housings until
you feel the tensioner just contact the springs.
,. Give each tensioner approximately two full turns to
preload the springs and tighten the jam nuts.
-. Reinstall the chip deflector.