Woodstock W1812 - Manual (Page 17)

-14-
N(/()Fne\ijDXelXcD]^%j`eZ\*&'0
J<
K
L
G
OFF Button
=`^li\12.Installing the belt guard and the
handwheel.
.. Place the belt onto the cutterhead pulley with the
belt direction arrow pointing the direction of pulley
rotation. When installed correctly, the internal belt
tangs must be facing against the pulley rotation arrow
shown in
=`^li\10.
/. Next, while keeping your fingers clear, lift the motor
and roll the belt onto the motor pulley as shown in
=`^li\11.
0. Attach the belt guard to the stand (=`^li\12) with
two 5 ⁄
16
"-18 x 3 ⁄
4
" hex bolts, four 5 ⁄
16
" flat washers,
and two 5 ⁄
16
"-18 hex nuts.
('. Slide the handwheel hub over the shaft (=`^li\12)
and tighten the set screw with a 5mm hex wrench.
=`^li\11.Installing the belt guard.
=`^li\10.Installing the drive belt
(belt cover removed for clarity).
Pulley
Rotation
Arrow
Internal
Belt Tang
Belt
Guard