Woodstock W1812 - Manual (Page 20)

-17-
N(/()Fne\ijDXelXcD]^%j`eZ\*&'0
J<
K
L
G
If, during the test run, you encounter an unusual noise
or vibration, stop using the machine immediately, then
review
KiflYc\j_ffk`e^ on GX^\+) for correction. If you
still cannot remedy a problem, contact our Tech Support
at (360) 734-3482 for assistance.
Kfk\jkilek_\dXZ_`e\#[fk_\j\jk\gj1
(. Make sure you understand the safety instructions
at the beginning of the manual, and verify that the
machine is setup properly.
). Ensure all tools and objects used during setup are
cleared away from the machine.
*. Use the elevation handwheel to raise the planer/
moulder head to provide plenty of room for the safe
operation of the feed rollers and the cutterhead.
+. Pull out the chip deflector retaining pin (=`^li\17)
and remove the chip deflector.
,. Wearing leather gloves, use a 14mm wrench to make
sure the knives are tight, and rotate the cutterhead
to make sure the knives do not hit the table.
-. Reinstall the chip deflector, and connect the
machine to the power source.
.. Push the OFF button in, then turn it clockwise so it
pops out ( =`^li\(/) to ensure it resets.
/. Turn the speed control dial (=`^li\(/)
counterclockwise to its slowest setting, then push
the ON button and the main motor will start.
0. Turn the speed control dial clockwise to operate and
speed up the feed rollers.
('. Press the OFF button to stop the machine.
((. WITHOUT resetting the OFF switch, press the ON
button. The machine should not start.
— If the machine does not start, the OFF button
safety feature is working correctly.
— If the machine starts, immediately disconnect
the machine from power. The OFF button safety
feature is at fault and must be replaced before
using this machine.
K\jkIle
Gifa\Zk`c\j k_ifne ]ifd k_\ dXZ_`e\
Zflc[ ZXlj\ j\i`flj \p\ `ealip. N\Xi
jX]\kp ^cXjj\j kf i\[lZ\ k_\ i`jb f]
`ealip.
=`^li\(/. Control panel.
=`^li\17.Removing the chip deflector.