John Deere SURFACE WATER PRO OMPFP11362 - Manual (Page 41)

Ditch
JS56696,00009E8 ­19­16MAY11­1/1
Create Best Fit Drain Design
Surface Water Pro Plus
Select MENU softkey >> GREENSTAR 3 PRO softkey
>> SURFACE WATER PRO softkey >> DITCH tab >>
PROFILE VIEW button >> EDIT DRAIN button.
The CREATE/EDIT DRAIN screen provides the ability to
create or edit a drain design associated with a ditch track.
The map shows the portion of the survey elevation that
is highlighted on the Full­View Map.
NOTE: The drain generated is a black line.
Cut Volume is calculated based on Implement
Width. Check before designing drains.
Best fit drain provides the operator with the ability to create
a drain design that utilizes existing ditch track vertical
profile while minimizing the amount of soil moved. This
is dependent upon the input parameters. It is possible
to get a NO SOLUTION with this feature. If software
fails to create a drain design, update image and adjust
parameters in Step 2 to produce a valid drain design.
1. Select drain type (A)—Best Fit.
2. Input: MIN Slope (%) (B), MAX Slope (%) (C), MIN
Cut (in.) (D), MAX Cut (in.) (E).
3. Select GENERATE DRAIN button (F). A black line is
displayed.
4. Drain design, visible by black line, is updated.
5. Cut Volume is updated.
PC13733
—UN—17MA
Y1
1
A—Drain Type drop­down
menu
B—Minimum Slope input box
C—Maximum Slope input box
D—Minimum Cut input box
E—Maximum Cut input box
F— Generate Drain button
G—Cancel button
H—Accept button
6. Repeat steps 2 and 3 until desired drain is created.
40­9 061611
PN=41