JBL SYNTHESIS SDP-40HD - Manual (Page 40)

SDP-40HD Basic Operation
2-28
standard 5.1-channel Dolby Digital source recorded without Dolby.
Digital Surround EX encoding is detected. The SDP-40HD cannot
automatically detect Dolby Digital Surround EX encoding in
non-flagged input sources.
HDCP STATUS ACTIVE, INACTIVE, ERROR
Indicates the current HDCP status of the media present at the
active HDMI input.
HDMI CONNECTOR 1-6
Indicates the HDMI connector selected as the active HDMI input.
INPUT
Indicates the selected input (for example, DVD1).
INPUT TYPE ANLG, BYPASS, PCM, ---
Indicates the input source that is present. When the parameter
setting is ANLG, a 2-channel analog audio source is present and the
ADVANCED menu ANALOG BYPASS parameter is set to OFF. When
the parameter setting is BYPASS, a 2-channel analog audio source is
present and the ANALOG BYPASS parameter is set to ON. When
the parameter setting is PCM, a 2-channel digital audio source is
present. When the parameter setting is ---, an unknown digital
audio source is present.
MIX ROOM SMALL, LARGE
Indicates the size of the mixing room that was used during the mixing
process. When the parameter setting is LARGE, you should set the
RE-EQUALIZER parameter to ON for THX listening modes.
MODE
Indicates the activated listening mode (e.g., L7 FILM).
SAMPLE RATE 44.1kHz, 48kHz, 88.2kHz, 96kHz
Indicates the sample rate of the input source that is present.
SURR MIX LVL +0.0dB, -3.0dB, -6.0dB
Indicates the relative surround channel level that was used during
the mixing process.
VERT RATE 60Hz, 50Hz, 59.94Hz, ---
Indicates the vertical timing rate for the active video format being
carried on HDMI.
VID FMT 720P, 1080I, ---
Indicates the active video format of the media present at the active
HDMI input.
WORD LENGTH 16 bits, 20 bits, 24 bits
Indicates the word length of the audio data present in the input signal.