JBL SYNTHESIS SDP-40HD - Manual (Page 21)

SDP-40HD Basic Operation
2-9
REMOTE CONTROL OVERVIEW
The SDP-40HD remote control provides full operation of the
SDP-40HD, including commands such as menu navigation that are
not available from the front-panel. The command matrix, beginning
on page 2-1100, indicates the commands that remote control
buttons perform when each command bank is active. The numbered
items in the matrix correspond with the remote control illustrations.
OPERATION CONSIDERATIONS
The following factors can improve or impede remote control
operation.
Note the following before operating the SDP-40HD remote con-
trol:
• The remote control must be in line of sight with the front-
panel IR receiver. Eliminate obstructions between the remote
control and the IR receiver. The remote control may become
unreliable if strong sunlight or fluorescent light shines on the IR
receiver.
• For optimal performance, position the remote control at a 30
degree angle no more than 17 feet (5m) from the SDP-40HD.
Placing the SDP-40HD inside a smoked glass cabinet will
reduce the remote control range.
• Remote controls for different components can interfere with
one another. Avoid using remote controls for different compo-
nents at the same time.
• Remote control batteries should be replaced as needed.
Input Connector Output Connector
(L) & (R) Front L/ R
(C) Center
(SUB) Subwoofer L/R & LFE
(LS) & (RS) Side L/R and Rear L/R