Juniper Networks ERX Hardware 8 - Manual (Page 24)

ERX 8.0.x Hardware Guide
Figure 2: ERX-14xx Models, Rear View
I/O
module
Power input
module
Cable
management
bracket
Plenum
Fan tray
SRP I/O
module
g013728
ERX-7xx Models
NOTE: In the E-series documentation, the term ERX-7xx models refers to both the
ERX-705 router and the ERX-710 router. The terms ERX-705 router and ERX-710
router refer to the specific models. See Figure 3 and Figure 4.
The ERX-7xx models are robust, high-density routers with less capacity
than the ERX-14xx models. The ERX-7xx models use either the
SRP-10G module or the SRP-5G module.
You can configure the ERX-7xx models to enable the line modules (LM) to operate
either at full line rate performance or at a rate dependent on the resources available.
For information about configuring performance of line modules, see JUNOSe
System Basics Configuration Guide, Chapter 6, Managing Modules.
NOTE: The 10-Gbps SRP module used in the ERX-310 router is different from the
10-Gbps SRP module used in the ERX-710 router. See “SRP Module” on page 10
for more information.
6 ERX Routers