Juniper Networks ERX Hardware 8 - Manual (Page 100)

ERX 8.0.x Hardware Guide
CAUTION: Do not change the IP address for the Ethernet interface that you are
using to communicate with the system. If you change the address, you will lose the
Telnet session.
SNMP
The system supports Simple Network Management Protocol (SNMP),
a standard management protocol for IP networks. You can configure
the system as an SNMP agent.
As an SNMP agent, the system provides access to management information
that it maintains. See JUNOSe System Basics Configuration Guide, Chapter 4,
Configuring SNMP for information on SNMP. See JUNOSe Command Reference
Guide A to M and JUNOSe Command Reference Guide N to Z for the commands
that are available for configuring the system as an SNMP agent.
The Next Step
See “Maintaining ERX Routers” on page 85.
82 The Next Step