IBM 201 - Manual (Page 87)

I2C Interface Test: Passed
Main Application Checksum: Passed
Boot Sector Checksum: Passed
Current System Management Adapter Status
Current BIST Results:
SRAM Memory Test: Passed
Serial Port 1 Test : Passed
Serial Port 2 Test: Passed
NVRAM Memory Test Passed
Realtime Clock Test Passed
Programmable Gate Array Test: Passed
I2C Interface Test: Passed
Main Application Checksum: Passed
Boot Sector Checksum: Passed
Onboard Ethernet Hardware Test: Passed
PCI EEPROM Initialization Test: Passed
5. When you are finished viewing this information, press Esc to return to the main
option menu. Remove the CD then restart the NAS 200 engine.
Troubleshooting the Remote Supervisor Adapter
1. Insert the Remote Supervisor Adapter Support CD into the CD-ROM drive and
restart the engine. If the engine does not boot from the CD-ROM, use
POST/BIOS setup to configure the CD-ROM drive as a boot device.
2. After the engine boots, the main option menu appears. The main menu contains
the following selections:
v Hardware Status and Information
v Configuration Settings
v Update System Management firmware
3. Use the up and down arrow keys to select Hardware Status and Information
and press Enter. The Hardware Status and Information menu contains the list
of devices with the following diagnostic test results:
System Management Processor Communication : Passed
-> Built in Self Test Status ...... : Passed
Boot Sector Code Revision ... :16, Build ID: CNET15A
Main Application Code Revision :16, Build ID: TUET15A
4. Use the up and down arrow keys to select the device you want to look at in
more detail. Press Enter. You will see a list of tests and results on the device:
Current System Management Processor Status
Current BIST Results:
SRAM Memory Test: Passed
Serial Port 1 Test : Passed
Serial Port 2 Test: Passed
NVRAM Memory Test Passed
Realtime Clock Test Passed
Programmable Gate Array Test: Passed
I2C Interface Test: Passed
Main Application Checksum: Passed
Boot Sector Checksum: Passed
Current System Management Adapter Status
Current BIST Results:
SRAM Memory Test: Passed
Serial Port 1 Test : Passed
Serial Port 2 Test: Passed
NVRAM Memory Test Passed
Realtime Clock Test Passed
Chapter 7. Troubleshooting 75