IBM 201 - Manual (Page 112)

Viewing the test log
The test log will not contain any information until after the diagnostic program has
run.
Note: If you already are running the diagnostic programs, begin with step 4
To view the test log:
1. Ensure a monitor, keyboard, and mouse is connected to the NAS 200.
2. Power on the NAS 200 engine and watch the screen.
If the NAS 200 engine is on, shut down your operating system and restart the
engine.
3. When the message F2 for Diagnostics appears, press F2.
If a power-on password or administrator password is set, you will be prompted
for it. Type in the appropriate password, then press Enter.
4. When the Diagnostic Programs screen appears, select Utility from the top of
the screen.
5. Select View Test Log from the list that appears; then, follow the instructions on
the screen.
The system maintains the test-log data while the NAS 200 is powered on. When
you turn off the power to the NAS 200, the test log is cleared.
Diagnostic error message tables
Table 18 describes the error messages that might appear when you run the
diagnostic programs.
Important: If diagnostic error messages appear that are not listed in Table 18,
make sure that your appliance has the latest levels of BIOS, Integrated System
Management Processor, ServeRAID, and diagnostics microcode.
In the following error codes, if XXX is 000, 195, or 197, do not replace a part.
These error codes have the following meanings:
000 The test passed.
195 Esc was pressed to end the test.
197 This is a warning error and may not indicate a hardware failure.
For all other error codes, replace the part or perform the actions indicated.
Table 18. Diagnostic error messages
Error Code Meaning FRU/action
001-XXX-000 Failed core tests System board
001-XXX-001 Failed core tests System board
001-250-000 Failed System board ECC System board
001-250-001 Failed Processor board ECC
1. Processor/PCI board
2. System board
005-XXX-000 Failed Video test System board
011-XXX-000 Failed COM1 Serial Port test System board
011-XXX-001 Failed COM2 Serial Port test System board
100 NAS 200 User’s Reference