Multi-Tech Systems MT3410ZLX-T/2 User Manual
Multi-Tech Systems Hardware
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- Chapter 1 - Introduction and Description
- Chapter 2 - Installation
- Safety Warnings
- Installing The MT3410ZLX or MT3410ZLX-T/2 Card(s)
- Driver Software Installation
- Novell NetWare Installation
- Novell Client Installation
- Microsoft LAN Manager Installation
- Packet Driver Installation
- Windows for Workgroups Installation (NDIS3 Driver for Workgroup)
- NDIS2 Driver for Workgroup
- ODI Driver for Workgroups
- Windows NT 3.51 / NT 4.0 Installation
- Windows 95 Installation
- Artisoft Lantastic 6.0 Installation
- Chapter 3 - Comprehensive Driver Notes
- Chapter 4 - Troubleshooting
- Introduction
- No response to AT commands
- The modem does not execute the command line
- The modem does not give a response after an AT command was executed
- The modem gives an 'ERROR' response after an AT command was executed
- The modem goes off-hook and disables the telephone line.
- The modem does not auto-answer the phone
- The software does not control the modem properly or can not detect the modem
- The characters on the screen are doubled
- No text appears on the screen in Data mode
- No text appears on the screen when in Command mode
- The modem does not dial a phone number after Execution of AT dial command
- communications software dials, but Fails
- The modem Connects with some modems, but not others
- When dialing another modem, You receive a 'CONNECT' response, but nothing else
- The modem speaker does not make any sound when Connecting to another modem
- The modem loses the connection when in use
- The modem does not connect with another modem
- Occasionally, the modem gives a burst of errors.
- The modem gets random errors in transmitted data.
- After Downloading a file, the File does not store on your disk drive
- The text on the screen is not legible
- When using V.42bis or MNP5, some features are disabled
- When connecting to another modem, the modem reports a higher Connect baud rate than it is really using
- When I run CARDEN, "PC-Card is not enabled successfully" is displayed
- Enabling the MT3410ZLX
- Installing the Win 95 Driver over SystemSoft CardWorks
- The NetWare driver runs successfully but fails to login to the Netware server
- COM Port and IRQ Conflicts
- Chapter 5 - Service
- Appendix A - Technical Specifications
- Appendix B - AT Commands, S-Registers & Result Codes
- Appendix C - Regulatory Agency Information
- Index