Multi-Tech Systems MT3410ZLX-T/2 - Manual (Page 73)

73
Appendices
S4= 0-127
S4 holds the decimal value of the character
recognized as a line feed (asynchronous operation
only). The line feed control character is output after
the carriage return control character, if verbose
result codes are enabled. The factory default is 010.
S5= 0-127
S5 holds the decimal value of the character
recognized as a backspace (asynchronous
operation only). The modem will not recognize the
backspace character if this register is set to a value
greater than 32. The factory default is 008.
S6 = 0-255
S6 sets the length of time, in seconds, that the
modem must wait (minimum 2 seconds even if the
value is less than 2) after going off-hook before
dialing the first digit of the telephone number
The factory default is 002.
S7=1-255 for international version. The factory
default is 060.
S7=0-58 for Japan version. The factory default is
058.
Set the time, in seconds, that the modem must wait
before hanging up because carrier is not detected.
S8= 0-255
S8 sets the time, in seconds, that the modem must
pause when the “,” dial modifier is encountered in
the dial string. The factory default is 002.