Multi-Tech Systems MT3410ZLX-T/2 - Manual (Page 44)

MultiMobile Owner’s Manual
44
When Using V.42bis or MNP5, Some Features
Are Disabled
C: You may be using a non-streaming protocol,
like Xmodem or Ymodem to transfer files.
Those are fine unless you are using V.42bis or
MNP5
S: When using V.42bis or MNP5, you should use a
streaming transfer protocol like Ymodem-G or
Zmodem.
S: Configure your software to use hardware flow
control (RTS/CTS ON).
When Connecting to Another Modem, the
Modem Reports a Higher Connect Baud Rate
than it Is Really Using
C: The modem defaults to report the modem-to-
computer baud rate when it responds with
CONNECT.
S: Go to Command mode with your
communication program (like Telix) and type
ATW2, then press Enter. This tells the modem
to report the modem-to-modem baud rate
instead.
When I Run CARDEN, “PC-Card Is Not Enabled
Successfully” Is Displayed
C: Your computer does not have enough memory
to map the attribute memory of your
MT3410ZLX.
S: If memory management software (e.g.,
EMM386) is installed, you must reserve an area
in upper memory (C000:0 — EFFF:F) for
MT3410ZLX attribute memory when enabling
the card.